CFGGEN Utility for IBM and LSI Basic or Integrated RAID =
Controllers=20

Supported controllers:
  - Onboard LSI 1064 SAS controller
  - Onboard LSI 1064e SAS controller
  - Onboard LSI 1068e SAS controller
  - Onboard LSI 1078 SAS controller
  - IBM SAS HBA (25R8060)
  - IBM 3Gb SAS HBA v2 (44E8700)
  - IBM SAS Expansion Card (CFFv) for IBM BladeCenter (39Y9190)
  - IBM SAS/SATA RAID Kit (42C1312, 42C1313)
  - IBM ServeRAID BR10i SAS controller (44E8688)
  - IBM ServeRAID BR10il SAS controller (44X0411)

NOTE TO SERVICE - Reference RETAIN #N/A

Version 2.10.00
 - Added appropriate message indicating that MAX volume size will be =
used when=20
   volume size specified is bigger than drive size.
 - Changed the error message and usage information of auto command to be =
more=20
   informative about the failure of the command.
 - Fixed issue where the execution of CFGGEN fails with "kernel too old" =
on=20
   Sles9 SP4/Rhel4.8 OS.

Version 2.06.01
 - Fixed issue where the display command would fail when SATA devices =
are
   attached.

Version 2.06.00
 - Added several fields in the output of DISPLAY.
 - Added support for single drive RAID 0 volumes.

Version 2.00.30
 - Added support for PPC platforms.
 - Added support for Solid State Drives (SSD) and added a check for SSD =
and=20
   non-SSD drive mix while creating a RAID volume or hotspare.
 - Added 512MB metadata support.
 - Fixed an issue where a hotspare drive could not be created in an =
enclosure.

Version 2.00.22
 - Added support for PPC platforms.
 - Fixed issue where BIOS version was displayed in hexadecimal.
 - Fixed an issue where CREATE would not create a volume with 9 or 10 =
drives.
 - Added dual hotspare support.

Version 2.00.15
 - Fixed an issue where, if SAS controllers are enumerated out of order, =
or
   enumeration begins past 0, the controllers are not seen.
 - Fixed an issue where a resyncing volume was reported as degraded, =
rather=20
   than resynching.
 - Changed the format of the BIOS version in the DISPLAY command to =
correctly=20
   report versions greater than 10.

Version 2.00.14
 - Added <Enclosoure:Bay> support for CREATE, HOTSPARE, and FORMAT =
commands.
 - Reformatted the output of the LIST command and added a new field.
 - Fixed an issue where the top byte of the subsystem vendor and device =
ID=20
   were truncanted in the output of the LIST command=20
 - Added an 'AUTO' command to create IR volumes without the need to =
specify=20
   drive IDs.
 - Added a LOCATE command to turn the identify LED on or off on drives =
in SEP
   devices.
=20
Version 2.00.10
 - Initial release